 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to vdc.
(2)
Connect positive (+) probe of multimeter to
MAIN POWER switch load position (black wire).
(3)
Connect negative (-) probe of multimeter to
GROUND quick-connect terminal block (above
main power switch).
(4)
Position MAIN POWER switch to ON and note
reading on multimeter.
(5)
If 24 vdc is not present, repair junction box
assembly (para 7-28).
VOLTAGE TEST
(1)
Set multimeter to vdc.
(2)
Connect positive (+) probe of multimeter to
junction box terminal board TB1 position 1.
(3)
Connect negative (-) probe of multimeter to
GROUND quick-connect terminal block (above
main power switch) and note reading on
multimeter.
(4)
If 24 vdc is not present, repair junction box
assembly (para 7-28).
(5)
Position MAIN POWER switch to OFF.
(6)
Close cover on junction box.
(7)
Tighten four screws on junction box cover.
2-1299
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals