 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
CONTINUITY TEST
(1)
Loosen four screws on junction box cover.
(2)
Open cover on juntion box.
(3)
Disconnect remote control cable from remote
control box.
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter on
pin E of connector on remote control cable.
(6)
Connect negative (-) probe on junction box
terminal board position 25 and note reading
on multimeter.
(7)
If continuity is not present, replace remote control
cable (para 7-96).
(8)
Close cover on junction box.
(9)
Tighten four screws on junction box cover.
2-1171
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals