CONTINUITY TEST - TM-9-2320-366-20-20249

TM 9-2320-366-20-2

CONTINUITY TEST

(1)

Set multimeter to ohms.

(2)

Connect jumper wire to connector J93-1.

(3)

Connect positive (+) probe of multimeter to

connector P43-1.

(4)

Connect negative (-) probe of multimeter to

jumper wire and note reading on multimeter.

(5)

If continuity is not present, repair wire 1403

(para 2-45) or replace engine control cable

assembly (para 7-80).

(6)

If continuity is present, replace ether sensor

(para 7-47).

(7)

Remove jumper wire from connector J93.

(8)

Connect connector J93 to ether valve

connector.

(9)

Connect connector clamp to ether valve

connector.

(10)

Connect connector J43 to connector P43.

(11)

Install instrument panel assembly (para 7-15).

2-1125