CONTINUITY TEST - TM-9-2320-366-20-20245

TM 9-2320-366-20-2

CONTINUITY TEST

(1)

Set multimeter to ohms.

(2)

Connect jumper wire to connector P42-1.

(3)

Lower cab (TM 9-2320-366-10-1).

(4)

Connect positive (+) probe of multimeter to

connector P31-15.

(5)

Connect negative (-) probe of multimeter to

jumper wire and note reading on multimeter.

(6)

If continuity is not present, repair wire 1403

(para 2-45) or replace engine control cable

assembly (para 7-80).

(7)

Raise cab (TM 9-2320-366-10-1).

(8)

Remove jumper wire from connector P42.

(9)

Connect connector P42 to ether sensor

connector.

(10)

Connect connector clamp on ether sensor

connector.

(11)

Lower cab (TM 9-2320-366-10-1).

2-1121