 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
terminal board TB1 terminal 37.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5)
If 24 vdc is not present, repair wire 1935
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
Position master power switch to off
(TM 9-2320-366-10-1).
(7)
Install PDP on dashboard with three screws.
(8)
Install three washers and screws in PDP.
(9)
Install kick panel (para 16-3).
CONTINUITY TEST
(1)
Remove instrument panel assembly for
access (para 7-15).
(2)
Disconnect connector PX1 from radiator fan
off switch.
(3)
Position radiator fan off switch to on
(TM 9-2320-366-10-1).
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter to
radiator fan off switch terminal 5.
(6)
Connect negative (-) probe of multimeter to
radiator fan off switch terminal 1.
(7)
If continuity is not present, replace radiator
fan off switch (para 7-18).
(8)
Position radiator fan off switch to off
(TM 9-2320-366-10-1).
2-1107
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals