 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Remove four nuts, washers, solenoid bracket,
washers, and screws.
(2)
Loosen screw and disconnect winch in
solenoid L4 connector from solenoid L4.
(3)
Set multimeter to volts dc.
(4)
Connect positive (+) probe of multimeter to
winch in solenoid L4 connector terminal 1.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position master power switch to on
(TM 9-2320-366-10-1).
(7)
Position PTO switch to on
(TM 9-2320-366-10-1).
(8)
Position winch power switch to on
(TM 9-2320-366-10-1).
(9)
Position WINCH IN/OUT switch to IN
(TM 9-2320-366-10-1) and note reading on
multimeter.
(10)
If 24 vdc is not present, go to step 3 of this
fault.
(11)
Position winch power switch to off
(TM 9-2320-366-10-1).
(12)
Position PTO switch to off
(TM 9-2320-366-10-1).
(13)
Position master power switch to off
(TM 9-2320-366-10-1).
2-987
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals