 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Remove kick panel (para 16-3).
(2)
Disconnect connector P99 from connector
J99.
(3)
Set multimeter to volts dc.
(4)
Connect positive (+) probe of multimeter to
connector P99-1.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 24 vdc is not present, repair wire 1803
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(8)
If 24 vdc is present, repair wire 1803
(para 2-45) or replace chemical alarm kit
cable assembly (para 7-59).
(9)
Position master power switch to off
(TM 9-2320-366-10-1).
(10)
Connect connector P99 to connector J99.
(11)
Install kick panel (para 16-3).
2-933
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals