CONTINUITY TEST - TM-9-2320-366-20-11487

TM 9-2320-366-20-1

CONTINUITY TEST

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter to

PDP, terminal 85, where relay K32 was

removed.

(3)

Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(4)

If continuity is not present, repair wire 3036

(para 2-45) or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle. Jewelry can catch on equipment and

cause injury or short across electrical circuit

and cause severe burns or electrical shock.

VOLTAGE TEST

(1) Set multimeter to volts dc.

(2) Connect positive (+) probe of multimeter to

PDP, terminal 30, where relay K32 was

removed.

(3) Connect negative (-) probe of multimeter to

ground.

(4) Position master power switch to on

(TM 9-2320-366-10-1) and note reading on

multimeter.

(5) If 24 vdc is not present, repair wire 26

(para 2-45) or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(6) Position master power switch to off

(TM 9-2320-366-10-1).

2-923