CONTINUITY TEST - TM-9-2320-366-20-11483

TM 9-2320-366-20-1

CONTINUITY TEST

(1)

Disconnect connector P6 from horn.

(2)

Set multimeter to ohms.

(3)

Connect positive (+) probe of multimeter to

connector P6.

(4)

Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(5)

If continuity is not present, repair wire 3035

(para 2-45) or replace front lights cable

assembly (para 7-82).

(6)

If continuity is present, replace horn

(para 7-53).

(7)

Connect connector P6 to horn.

(8)

Position front grille on cab with washer and

screw.

(9)

Position two washers and screws in front

grille.

(10)

Tighten screw to 48-60 lb-in. (5-7 Nm).

(11)

Tighten two screws to 24 lb-in. (3 Nm).

2-919