 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Remove PDP cover (para 16-2).
(2)
Remove three screws and washers from PDP.
(3)
Remove three screws from PDP.
(4)
Lift PDP outward to gain access.
(5)
Disconnect connector PX22 from windshield
wiper motor.
(6)
Set multimeter to volts dc.
(7)
Connect positive (+) probe of multimeter to
connector PX22-4.
(8)
Connect negative (-) probe of multimeter to
ground.
(9)
Position master power switch to on
(TM 9-2320-366-10-1).
(10)
Position windshield wiper switch to high
(TM 9-2320-366-10-1) and note reading on
multimeter.
(11)
If 24 vdc is not present, go to step 2 of this
fault.
(12)
If 24 vdc is present, replace windshield
wiper motor (para 18-4).
(13)
Position windshield wiper switch to off
(TM 9-2320-366-10-1).
(14)
Position master power switch to off
(TM 9-2320-366-10-1).
(15)
Connect connector PX22 to windshield
wiper motor.
2-911
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals