 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Disconnect connector J2 from connector P2.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
connector J2-2.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6)
If 24 vdc is not present, repair wire 1569
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(7)
If 24 vdc is present, replace windshield
wiper EMI cable (para 7-68).
(8)
Position master power switch to off
(TM 9-2320-366-10-1).
(9)
Connect connector P2 to connector J2.
(10)
Install PDP on dashboard with three screws.
(11)
Install three washers and screws in PDP.
(12)
Install PDP cover (para 16-2).
CONTINUITY TEST
(1)
Disconnect connector J2 from connector P2.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
connector J2-3.
(4)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5)
If continuity is not present, repair wire 3037
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
If continuity is present, replace
windshield wiper EMI cable (para 7-68).
(7)
Connect connector P2 to connector J2.
(8)
Install PDP on dashboard with three screws.
(9)
Install three washers and screws in PDP.
(10)
Install PDP cover (para 16-2).
2-899
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals