 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
connector PX22-1.
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
If continuity is not present, go to step 5 of
this fault.
(5)
Connect connector PX22 to windshield
wiper motor.
CONTINUITY TEST
(1)
Remove instrument panel assembly for access
(para 7-15).
(2)
Disconnect turn signal switch connector from
connector P18.
(3)
Set multimeter to ohms.
(4)
Connect positive (+) probe of multimeter to
turn signal switch connector terminal 6.
(5)
Connect negative (-) probe of multimeter to
turn signal switch connector terminal 4.
(6)
Position windshield wiper switch to high
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If continuity is not present, replace turn
signal switch (para 7-26).
(8)
If continuity is present, replace windshield
wiper motor (para 18-4).
(9)
Position windshield wiper switch to off
(TM 9-2320-366-10-1).
(10)
Connect turn signal switch connector to
connector P18.
(11)
Install instrument panel assembly (para 7-15).
(12)
Install PDP on dashboard with three screws.
(13)
Install three washers and screws in PDP.
(14)
Install PDP cover (para 16-2).
2-897
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals