 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Disconnect connector J2 from connector P2.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
connector J2-5.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1).
(6)
Position windshield wiper switch to low
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 24 vdc is not present, repair wire 1527
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(8)
If 24 vdc is present, replace windshield wiper
EMI cable (para 7-68).
(9)
Position windshield wiper switch to off
(TM 9-2320-366-10-1).
(10)
Position master power switch to off
(TM 9-2320-366-10-1).
(11)
Connect connector J2 to connector P2.
(12)
Install PDP on dashboard with three screws.
(13)
Install three washers and screws in PDP.
(14)
Install PDP cover (para 16-2).
CONTINUITY TEST
(1)
Disconnect windshield wiper ECU
from connector PX21.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
connector PX21-4.
(4)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5)
If continuity is not present, repair wire 3034
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
2-891
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals