 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
connector PX22-2.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position master power switch to on
(TM 9-2320-366-10-1).
NOTE
24 vdc is indicated for approximately
1 (one) second.
(5) Position windshield wiper switch to low
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6) If 24 vdc is not present, go to step 5 of
this fault.
(7) Position windshield wiper switch to off
(TM 9-2320-366-10-1).
(8) Position master power switch to off
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1)
Remove instrument panel assembly for access
(para 7-15).
(2)
Disconnect turn signal switch connector from
connector P18.
(3)
Set multimeter to ohms.
(4)
Connect positive (+) probe of multimeter to
turn signal switch connector terminal 4.
(5)
Connect negative (-) probe of multimeter to
turn signal switch connector terminal 5.
(6)
Position windshield wiper switch to low position
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If continuity is not present, replace turn
signal switch (para 7-26).
(8)
Position windshield wiper switch to off
(TM 9-2320-366-10-1).
(9)
Connect turn signal switch connector to
connector P18.
(10)
Install instrument panel assembly (para 7-15).
2-889
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals