 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Remove instrument panel assembly for access
(para 7-15).
(2)
Disconnect connector P18 from turn signal
switch connector.
(3)
Set multimeter to volts dc.
(4)
Connect positive (+) probe of multimeter to
connector P18-4.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position master power switch to on
(TM 9-2320-366-10-1).
(7)
Press windshield washer switch
(TM 9-2320-366-10-1) and note reading on
multimeter.
(8)
If 24 vdc is not present, repair wire 1569
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(9)
Position master power switch to off
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
turn signal switch connector terminal 4.
(3)
Connect negative (-) probe of multimeter to
turn signal switch connector terminal 8.
(4)
Press windshield washer switch
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5)
If continuity is not present, replace turn
signal switch (para 7-26).
(6)
Connect connector P18 to turn signal switch
connector.
(7)
Install instrument panel assembly (para 7-15).
2-881
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals