 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Remove personnel heater for access (para 18-9).
(2)
Disconnect connector PX25 from personnel
heater connector.
(3)
Set multimeter to volts dc.
(4)
Connect positive (+) probe of multimeter to
connector PX25-1.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position master power switch to on
(TM 9-2320-366-10-1).
(7)
Position main light switch auxiliary lever to
PNL BRT (TM 9-2320-366-10-1).
(8)
Position dimmer switch to maximum
brightness (TM 9-2320-366-10-1) and note
reading on multimeter.
(9)
If 12 vdc is not present, repair wire 1908
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(10)
If 12 vdc is present, replace or repair personnel
heater (para 18-9).
(11)
Position master power switch to off
(TM 9-2320-366-10-1).
(12)
Position main light switch auxiliary lever to
OFF (TM 9-2320-366-10-1).
(13)
Connect connector PX25 to personnel heater
connector.
(14)
Install personnel heater (para 18-8).
2-867
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals