 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector P52R from connector
J52.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P52R pin 6.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position master power switch to on
(TM 9-2320-366-10-1).
(6) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(7) Apply brakes and note reading on
multimeter.
(8) If 12 VDC is not present, repair wire
22C from connector P51 socket 13 to
connector P52R pin 6 (para 2-45) or
replace rear lights cable assembly
(para 7-84 or 7-104).
(9) If 12 VDC is present, replace rear
intervehicular 12 VDC (7 pin) cable
(para 7-128).
(10) Position main light switch to OFF
(TM 9-2320-366-10-1).
(11) Position master power switch to off
(TM 9-2320-366-10-1).
NOTE
Install plastic cable ties as required.
(12) Connect connector P52R to connector J52.
Change 1
2-857
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals