 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Lift cover on connector J95 intervehicular
12 VDC connector.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector J95 pin 4.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position master power switch to on
(TM 9-2320-366-10-1).
(6) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(7) Apply brakes and note reading on
multimeter.
(8) If 12 VDC is not present, go to step 2
of this fault.
(9) If 24 VDC is present, perform Electrical
System Troubleshooting (e61. One or
Both Stoplights Do Not Illuminate) if towed
vehicle is FMTV. If towed vehicle is not
FMTV, refer to towed vehicle TM for
troubleshooting procedures.
(10) Position main light switch to OFF
(TM 9-2320-366-10-1).
(11) Position master power switch to off
(TM 9-2320-366-10-1).
Change 1
2-853
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals