 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter
to relay K29 terminal 86 on PDP.
(3) Connect negative (-) probe of multimeter to
ground.
(4) Position main light switch to BO DRIVE
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5) If 12 VDC is not present, repair wire 1408
from relay K29 terminal 86 on PDP to
terminal board TB1 position 53 (para 2-45)
or replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to relay K29 terminal 85 on PDP.
(3) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(4) If continuity is not present, repair wire
3040 from K29 terminal 85 on PDP to
terminal board TB2 position 20 (para 2-45)
or replace WTEC II dashboard assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(5) If continuity is present, replace relay K29
(para 7-9).
(6) Install relay K29 in PDP.
(7) Install PDP cover (para 16-2).
Change 1
2-821
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals