 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Loosen six screws and remove cover and
preformed packing from composite taillight
assembly housing. Discard preformed
packing.
(2) Remove lamp from socket.
(3) Set multimeter to volts DC.
(4) Connect positive (+) probe of multimeter
to blackout stoplight lamp socket center
contact.
(5) Connect negative (-) probe of multimeter to
ground.
(6) Position master power switch to on
(TM 9-2320-366-10-1).
(7) Position main light switch to BO DRIVE
(TM 9-2320-366-10-1).
(8) Apply brakes and note reading on
multimeter.
(9) If 12 VDC is not present, go to step 4 of
this fault.
(10) Position master power switch to off
(TM 9-2320-366-10-1).
(11) Position main light switch to OFF
(TM 9-2320-366-10-1).
Change 1
2-763
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals