 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
CONTINUITY TEST
(1)
Disconnect connector PX14 from hazard
lights switch.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
connector PX20-A.
(4)
Connect negative (-) probe of multimeter to
connector PX14-6 and note reading on
multimeter.
(5)
If continuity is not present, repair wire 1568
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
Connect connector PX14 to hazard lights
switch.
(7)
Install instrument panel assembly (para 7-15).
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
connector PX20-C.
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
If continuity is not present, repair wire 3049
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(5)
If continuity is present, replace flasher unit
(para 7-25).
(6)
Connect connector PX20 to flasher unit.
(7)
Install flasher unit on dashboard with two
washers and screws.
(8)
Install kick panel (para 16-3).
2-733
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals