 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
PDP, socket 30, where relay K13 was
removed.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
If 12 vdc is not present, repair wire 509
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
VOLTAGE TEST
(1)
Install relay K13 in PDP.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
relay K13 terminal 87.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(6)
Position warning light switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 12 vdc is not present, replace relay K13
(para 7-9).
(8)
Position warning light switch to off
(TM 9-2320-366-10-1).
(9)
Position main light switch to OFF
(TM 9-2320-366-10-1).
2-667
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals