Click here to make tpub.com your Home Page

Page Title: VOLTAGE TEST
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home
   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Disconnect connector P62A from connector
J62.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
connector J62-B.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(6)
Position warning light switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 12 vdc is not present, go to step 5 of this
fault.
(8)
If 12 vdc is present, repair wire 509 (L/R)
(para 2-45) or replace M1089 warning lights
cable assembly (para 22-4).
(9)
Position warning light switch to off
(TM 9-2320-366-10-1).
(10)
Position main light switch to OFF
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter to
connector J62-A.
(3)
Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4)
If continuity is not present, repair wire 3050
(para 2-45) or replace warning light cable
assembly (para 22-5).
(5)
If continuity is present, repair wire 3050 (L/R)
(para 2-45) or replace M1089 warning lights
cable assembly (para 22-4).
(6)
Connect connector P62A to connector J62.
2-661

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business