VOLTAGE TEST - TM-9-2320-366-20-11187

TM 9-2320-366-20-1

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle. Jewelry can catch on equipment and

cause injury or short across electrical circuit

and cause severe burns or electrical shock.

VOLTAGE TEST

(1)

Remove PDP cover (para 16-2).

(2)

Remove three screws and washers from PDP.

(3)

Remove three screws from PDP.

(4)

Lift PDP outward to gain access.

(5)

Disconnect connector J27 from connector

P27.

(6)

Set multimeter to volts dc.

(7)

Connect positive (+) probe of multimeter to

J27-7.

(8)

Connect negative (-) probe of multimeter to

ground.

(9)

Position main light switch to BO DRIVE

(TM 9-2320-366-10-1) and note reading on

multimeter.

(10)

If 12 vdc is not present, repair wire 19

(para 2-45) or replace WTEC II dashboard cable

assembly (para 7-10) or WTEC III dashboard

cable assembly (para 7-11).

(11)

Position main light switch to OFF

(TM 9-2320-366-10-1).

(12)

Connect connector J27 to connector P27.

(13)

Install PDP on dashboard with three screws.

(14)

Install three washers and screws in PDP.

(15)

Install PDP cover (para 16-2).

2-633