 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove two screws, lockwashers, LH
composite taillight assembly, and
terminal lug TL18 from right taillight
carrier. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter to
terminal lug TL18.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, go to step 21
of this fault.
(6) If continuity is present, replace LH
composite taillight assembly (para 7-39).
(7) Install terminal lug TL18, and LH composite
taillight assembly on left taillight carrier
with two lockwashers and screws.
(8) Connect connector P78 to LH composite
taillight assembly.
(9) Install LH composite taillight lamp in
socket.
(10) Install preformed packing and cover on LH
composite taillight assembly with six
screws.
Change 1
2-612.13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals