 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Disconnect connector P52R from connector
J52R.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter to
connector P52R pin 1.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) If 12 VDC is not present, repair wire 21
from connector P51 socket 3 to splice
E20 (para 2-45) or replace M1083/M1084/
M1085/M1090/M1092/M1093/M1094/
M1096 rear lights cable assembly (para 7-84)
or M1086/M1088/M1089 rear lights cable
assembly (para 7-104).
(7) If 12 VDC is present, repair wire 3094 from
terminal lug TL92 to splice E72 (para 2-45)
or replace M1083M1084/M1085/M1090/
M1092/M1093/M1094/M1096 (para 7-84)
or M1086/M1088/M1089 rear lights cable
assembly (para 7-104).
(8) Position main light switch to OFF
(TM 9-2320-366-10-1).
(9) Connect connector J52 to connector P52R.
Change 1
2-612.7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals