 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Remove PDP cover (para 16-2).
(2) Remove three screws and washers from
PDP.
(3) Remove three screws from PDP.
(4) Lift PDP outward to gain access.
(5) Disconnect connector P51 from connector
J51.
(6) Set multimeter to volts DC.
(7) Connect positive (+) probe of multimeter to
connector J51 pin 3.
(8) Connect negative (-) probe of multimeter to
ground.
(9) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(10) If 12 VDC is not present, go to step 14 of
this fault.
(11) Position main light switch to OFF
(TM 9-2320-366-10-1).
(12) Connect connector J51 to connector P51.
(13) Install PDP on dashboard with three screws.
(14) Install three washers and screws in PDP.
Change 1
2-612.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals