 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1)
Remove nut, lockwasher, terminal lug TL32,
and lockwasher from RH rear marker light
screw. Discard lockwashers.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter
to terminal lug TL31.
(4)
Connect negative (-) probe of multimeter to
terminal lug TL32 and note reading on
multimeter.
(5)
If continuity is not present, repair wire 3094
from terminal TL31 to terminal lug TL32
(para 2-45) and go to step 3 of this fault if
required or replace M1088 rear lights cable
assembly (para 7-104) and go to step 1 of
this fault.
(6)
If continuity is present, replace LH rear
marker light (para 7-38) and go to step 3 of
this fault if required.
(7)
Install lockwasher, terminal lug TL31,
lockwasher, and nut on middle rear marker
light screw.
(8)
Install lockwasher, terminal lug TL32,
lockwasher, and nut on RH rear marker
light screw.
Change 1
2-604.183
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals