|
|
TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL30,
and lockwasher from LH rear marker light
screw. Discard lockwashers.
(2) Remove nut, lockwasher, terminal lug TL31,
and lockwasher from middle rear marker light
screw. Discard lockwashers.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to terminal lug TL30.
(5) Connect negative (-) probe of multimeter to
terminal lug TL31 and note reading on
multimeter.
(6) If continuity is not present, repair wire
3094 from terminal TL30 to terminal lug
TL31 (para 2-45) and go to step 3 of this
fault if required or replace M1088 rear
lights cable assembly (para 7-104) and
go to step 1 of this fault.
(7) Install lockwasher, terminal lug TL30,
lockwasher, and nut on LH rear maker
light screw.
(8) Install LH rear marker light lamp in
socket.
(9) Install lens cover on LH rear marker light
base with two screws.
Change 1
2-604.181
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |