 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL20,
and lockwasher from RH rear marker light
screw. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug TL20.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire
3095 from terminal lug TL20 to terminal
lug TL21 (para 2-45) and go to step 9 of
this fault if required or replace M1085/
M1096 rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(6) If continuity is present, replace RH rear
marker light (para 7-38) and go to step 9
of this fault if required.
(7) Install lockwasher, terminal lug TL20,
lockwasher, and nut on RH rear marker
light screw.
(8) Connect RH rear marker light connector
to connector P89.
Change 1
2-604.159
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals