 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug TL16,
and lockwasher from LH rear marker light
screw. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug TL16.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire
3094 from terminal lug TL16 to terminal
lug TL18 (para 2-45) and go to step 46 of
this fault if required or replace M1085/
M1096 rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(6) If continuity is present, replace LH rear
marker light (para 7-38) and go to step 46
of this fault if required.
(7) Install lockwasher, terminal lug TL16,
lockwasher, and nut on LH rear marker light
screw.
(8) Connect LH rear marker light connector
to connector P86.
Change 1
2-604.155
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals