 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug
TL15, and lockwasher from LH side marker
light screw. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug TL15.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire
3094 from terminal lug TL15 to terminal
lug TL16 (para 2-45) and go to step 8 of
this fault if required or replace M1086/
M1089 rear lights cable assembly
(para 7-104) or M1086/M1096 rear lights
cable assembly (para 7-84) and go to step
1 of this fault.
(6) If continuity is present, replace LH side
marker light (para 7-38) and go to step 8
of this fault if required.
(7) Install lockwasher, terminal lug TL15,
lockwasher, and nut on LH side marker
light.
(8) Connect LH side marker light connector
to connector 85.
Change 1
2-604.141
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals