 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug
TL89, and lockwasher from RH intermediate
marker light screw. Discard lockwashers.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to terminal lug TL89.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If continuity is not present, repair wire
3090 from terminal lug TL89 to terminal
lug TL90 (para 2-45) and go to step 6 of
this fault if required or replace M1086/
M1089 rear lights cable assembly
(para 7-104) or M1085/M1096 rear lights
cable assembly (para 7-84) and go to step
1 of this fault.
(6) If continuity is present, replace RH
intermediate marker light (para 7-38) and
go to step 6 of this fault if required.
(7) Install lockwasher, terminal lug TL89,
lockwasher, and nut on RH intermediate
marker light screw.
(8) Connect RH intermediate marker light
connector to connector P95.
Change 1
2-604.103
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals