 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Remove PDP cover (para 16-2).
(2)
Remove circuit breaker CB67 from PDP.
(3)
Set multimeter to volts DC.
(4)
Connect positive (+) probe of multimeter to
circuit breaker CB67 socket 3 on PDP.
(5)
Connect negative (-) probe of multimeter to
ground.
(6)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 12 VDC is not present, go to step 2 of
this fault.
(8)
If 12 VDC is present, repair wire 1912 from
circuit breaker CB67 socket 3 to terminal
board TB1 position 26 (para 2-45) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(9)
Position main light switch to OFF
(TM 9-2320-366-10-1).
Change 1
2-604.57
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals