 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector P88 from RH rear
side marker light connector.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter
to connector P88.
(4) Connect negative (-) probe of multimeter
to ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) If 12 VDC is not present, repair wire 489
from connector P88 to splice E17
(para 2-44) and go to step 6 of this fault
if required or replace rear lights cable
assembly (para 7-84) and go to step 1
of this fault.
(7) If 12 VDC is present, repair wire 489 from
connector P88 to splice E17 (para 2-45)
and go to step 6 of this fault if required
or replace rear lights cable assembly
(para 7-84) and go to step 1 of this fault.
(8) Position main light switch to OFF
(TM 9-2320-366-10-1).
NOTE
Install plastic cable ties as required.
(9) Connect connector P88 to RH rear side
marker light connector.
Change 1
2-604.55
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals