CONTINUITY TEST - TM-9-2320-366-20-10975

TM 9-2320-366-20-1

CONTINUITY TEST

(1) Remove nut, lockwasher, terminal lug TL19,

and lockwasher from RH side marker light

screw. Discard lockwashers.

(2) Set multimeter to ohms.

(3) Connect positive (+) probe of multimeter to

terminal lug TL19.

(4) Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(5) If continuity is not present, repair wire 3095

from terminal lug TL19 to terminal lug TL20

(para 2-45) and go to step 6 of this fault if

required or replace rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

(6) If continuity is present, replace RH side

marker light (para 7-38) and go to step 5

of this fault if required.

(7) Install lockwasher, terminal lug TL19,

lockwasher, and nut on RH side marker

light screw.

(8) Connect RH side marker light connector to

connector P88.

Change 1

2-604.43