 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove nut, lockwasher, terminal lug
TL30, and lockwasher from LH rear marker
light screw. Discard lockwashers.
(2) Remove nut, lockwasher, terminal lug
TL31, and lockwasher from middle rear
marker light screw. Discard lockwashers.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to terminal lug TL30.
(5) Connect negative (-) probe of multimeter to
terminal lug TL31 and note reading on
multimeter.
(6) If continuity is not present, repair wire
3094 from terminal lug TL30 to terminal lug
TL31 (para 2-45) or replace rear lights cable
assembly (para 7-84).
(7) If continuity is present, replace LH rear
marker light (para 7-38).
(8) Install lockwasher, terminal lug TL31,
lockwasher, and nut on middle rear marker
light screw.
(9) Install lockwasher, terminal lug TL30,
lockwasher, and nut on LH rear marker
light screw.
(10) Install LH rear marker light lamp in socket.
(11) Install lens cover on LH rear marker light
base with two screws.
Change 1
2-600.9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals