 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove four screws from LH cab marker
light base.
NOTE
Do not let wires slip through hole into cab
structure. If wires slip into cab structure,
vehicle will need further disassembly to
retrieve wires.
(2) Remove nut, lockwasher, terminal lug
TL133, and lockwasher from LH cab
marker light base. Discard lockwashers.
(3) Extend base and disconnect connector
P129 from marker light connector.
(4) Remove gasket from LH cab marker light
base. Discard gasket.
(5) Set multimeter to ohms.
(6) Connect positive (+) probe of multimeter
to terminal lug TL130.
(7) Connect negative (-) probe of multimeter
to terminal lug TL133 and note reading
on multimeter.
(8) If continuity is not present, repair wire
3098 from terminal lug TL130 to terminal
lug TL133 (para 2-45) or replace LH door
and cab marker lights cable assembly
(para 7-61).
(9) If continuity is present, replace LH door
marker light (para 7-38).
(10) Install gasket on LH cab marker light base.
(11) Connect marker light connector to
connector P129.
(12) Install lockwasher, terminal lug TL133,
lockwasher, and nut on back of LH cab
marker light base.
(13) Install LH cab marker light base on vehicle
with four screws.
(14) Install LH cab marker light lamp in socket.
(15) Install lens cover on base with two screws.
(16) Install gasket on LH door marker light base.
(17) Connect marker light connector to
connector P130.
(18) Install lockwasher, terminal lug TL130,
lockwasher, and nut on back of LH door
marker light base.
(19) Install LH door marker light base on vehicle
with four screws.
(20) Install LH door marker light lamp in socket.
(21) Install lens cover on base with two screws.
Change 1
2-570.5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals