 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1) Remove two screws and lens cover from
LH cab marker light base.
(2) Remove LH cab marker light lamp from
socket.
(3) Set multimeter to ohms.
(4) Check continuity through LH cab marker
light lamp and note reading on multimeter.
(5) If continuity is not present, replace LH cab
marker light lamp (para 7-38).
CONTINUITY TEST
(1) Remove two screws and lens cover from
LH door marker light base.
(2) Remove LH door marker light lamp from
socket.
(3) Remove four screws from LH door marker
light.
NOTE
Do not let wires slip through hole into cab
structure. If wires slip into cab structure,
vehicle will need further disassembly to
retrieve wires.
(4) Remove nut, lockwasher, terminal lug
TL130, and lockwasher from LH door
marker light base. Discard lockwashers.
(5) Extend base and disconnect connector
P130 from marker light connector.
(6) Remove gasket from LH door marker light
base. Discard gasket.
(7) Set multimeter to ohms.
(8) Connect positive (+) probe of multimeter
to terminal lug TL130.
(9) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(10) If continuity is not present from terminal lug
TL130 to ground, go to step 12 of this
fault.
Change 1
2-569
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals