CONTINUITY TEST - TM-9-2320-366-20-10845

TM 9-2320-366-20-1

CONTINUITY TEST

(1)

Set multimeter to ohms.

(2)

Connect positive (+) probe of multimeter to

PDP, terminal 85, where relay K8 was

removed.

(3)

Connect negative (-) probe of multimeter to

ground and note reading on multimeter.

(4)

If continuity is not present, repair wire 3053

(para 2-45) or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(5)

If continuity is present, replace relay K8

(para 7-9).

(6)

Install relay K8 in PDP.

(7)

Install PDP cover (para 16-2).

WARNING

Remove rings, bracelets, watches, necklaces,

and any other jewelry before working around

vehicle. Jewelry can catch on equipment and

cause injury or short across electrical circuit

and cause severe burns or electrical shock.

VOLTAGE TEST

(1) Remove instrument panel assembly for access

(para 7-15).

(2) Disconnect connector P18 from connector

J18.

(3) Set multimeter to volts dc.

(4) Connect positive (+) probe of multimeter to

connector P18-3.

(5) Connect negative (-) probe of multimeter to

ground.

(6) Position main light switch to SER DRIVE

(TM 9-2320-366-10-1) and note reading on

multimeter.

(7) If 12 vdc is not present, repair wire 16A

(para 2-45) or replace WTEC II dashboard

cable assembly (para 7-10) or WTEC III

dashboard cable assembly (para 7-11).

(8) Position main light switch to OFF

(TM 9-2320-366-10-1).

2-551