 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
CONTINUITY TEST
(1)
Remove PDP cover (para para 16-2).
(2)
Remove relay K8 from PDP.
(3)
Disconnect connector P14 (RH) or connector
P20 (LH) from housing.
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter to
PDP, terminal 87A, where relay K8 was
removed.
(6)
Connect negative (-) probe of multimeter to
connector P14 (RH) or connector P20 (LH)
and note reading on multimeter.
(7)
If continuity is not present, go to step 8
of this fault.
(8)
Connect connector P14 (RH) or connector P20
(LH) to housing.
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
PDP, terminal 86, where relay K8 was
removed.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(5)
Position headlight high beams to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6)
If 12 vdc is not present, go to step 6 of
this fault.
(7)
Position main light switch to OFF
(TM 9-2320-366-10-1).
2-549
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals