 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
OPERATIONAL TEST
(1)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(2)
Position headlight high beams on
(TM 9-2320-366-10-1).
(3)
If both headlights high beams do not
illuminate, and go to step 3 of this fault.
(4)
Position main light switch to OFF
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1)
Remove three screws and retaining ring
from housing.
(2)
Remove headlight lamp from housing.
(3)
Disconnect headlight lamp wire 17 from
housing.
(4)
Disconnect headlight lamp wire 91 from
housing.
(5)
Set multimeter to ohms.
(6)
Connect positive (+) probe of multimeter to
headlight lamp wire 17.
(7)
Connect negative (-) probe of multimeter to
headlight lamp wire 91 and note reading on
multimeter.
(8)
If continuity is not present, replace headlight
lamp (para 7-41).
(9)
If continuity is present, repair wire 17
(para 2-45) or replace front lights cable
assembly (para 7-82).
(10)
Connect headlight lamp wire 17 to housing.
(11)
Connect headlight lamp wire 91 to housing.
(12)
Install headlight lamp in housing.
(13)
Install retaining ring on housing with three
screws.
2-547
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals