 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CONTINUITY TEST
(1)
Set multimeter to ohms.
(2)
Connect positive (+) probe of multimeter
to PDP terminal 85, where relay K7 was
removed.
(3)
Connect negative (-) probe of multimeter
to ground and note reading on
multimeter.
(4)
If continuity is not present, repair wire
3002 from PDP relay K7 terminal 85 to
terminal board TB2 position 74
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter
to PDP terminal 30, where relay K7 was
removed.
(3) Connect negative (-) probe of multimeter
to ground.
(4) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5) If 12 VDC is not present, Repair wire
1416 from PDP relay K7 terminal 30
to circuit breaker CB78 (para 2-45) or
replace WTEC II dashboard cable
assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
Change 1
2-537
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals