 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuit
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Disconnect connector J108 from connector
P108.
(2)
Set multimeter to volts dc.
(3)
Connect positive (+) probe of multimeter to
connector J108-18.
(4)
Connect negative (-) probe of multimeter to
ground.
(5)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(6)
If 24 vdc is not present, repair wire 2034
(para 2-45) or replace auxiliary panel cable
assembly (para 7-58).
(7)
If 24 vdc is present, repair wire 2034
(para 2-45) or replace M1090/M1094 dump
power cable assembly (para 7-125).
(8)
Position master power switch to off
(TM 9-2320-366-10-1).
(9)
Connect connector P108 to connector J108.
(10)
Connect connector P172 to connector J172.
(11)
Lower dump bed (TM 9-2320-366-10-1).
(12)
Install personnel heater (para 18-9).
2-497
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals