 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Raise cab (TM 9-2320-366-10-1).
(2) Disconnect connector clamp from coolant
temperature light switch connector,
(3) Disconnect connector P37 from coolant
temperature light switch.
(4) Set multimeter to ohms.
(5) Connect positive (+) probe of multimeter to
coolant temperature light switch connector
socket 2.
(6) Connect negative (-) probe of multimeter to
known good ground and note reading on
multimeter.
(7) If continuity is not present, go to step 3 of this
fault.
(8) If continuity is present, replace coolant
temperature light switch (para 7-22).
(9) Connect connector P37 to coolant
temperature light switch.
(10) Connect connector clamp to coolant
temperature light switch connector.
(11) Lower cab (TM 9-2320-366-10-1).
Change 2
2-418.5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals