 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
CONTINUITY TEST
(1)
Loosen four captive screws in lamp mounting
panel.
(2)
Remove lamp mounting panel from lighted
indicator display housing.
(3)
Remove high engine temperature lamps from
printed circuit board.
(4)
Set multimeter to ohms.
(5)
Check continuity through each high engine
temperature indicator lamp and note
reading on multimeter.
(6)
If continuity is not present, replace lamp
(para 7-16).
(7)
If continuity is present, replace lighted
indicator display (para 7-16).
(8)
Install high engine temperature lamps in printed
circuit board.
(9)
Install lamp mounting panel in lighted indicator
display housing.
(10)
Tighten four captive screws in lamp mounting
panel.
(11)
Connect lighted indicator display to connector
PX7.
(12)
Position lighted indicator display in instrument
panel assembly with four screws.
(13)
Tighten four screws to 6-10 lb-in. (1 Nm).
(14)
Connect batteries (para 7-57).
2-417
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals