 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
"A" switch connector terminal 1.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position main light switch auxiliary lever to
PANEL BRT (TM 9-2320-366-10-1).
(5)
Position dimmer switch to maximum
brightness (TM 9-2320-366-10-1).
(6)
Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading on
multimeter.
(7)
If 12 vdc is not present, repair wire 1908
(para 2-45) or replace auxiliary panel cable
assembly (para 7-58).
(8)
If 12 vdc is present, repair wire 3020
(para 2-45) or replace auxiliary panel cable
assembly (para 7-58).
(9)
Position main light switch to OFF
(TM 9-2320-366-10-1).
(10)
Connect PTO switch connector to PTO
switch.
(11)
Position auxiliary panel on auxiliary panel
housing with six screws.
(12)
Tighten six screws to 24 lb-in. (3 Nm).
2-407
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals