 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
CONTINUITY TEST
(1) Disconnect connector clamp from WATER
TEMP gage connector.
(2) Disconnect connector PX11 from WATER
TEMP gage connector.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter to
connector PX11 socket 2.
(5) Connect negative (-) probe of multimeter to
connector PX24 pin 2 and note reading on
multimeter.
(6) If continuity is not present, repair wire 1908
from connector PX11 socket 2 to connector
PX24 socket 2 (para 2-45) or replace
WTEC II dashboard cable assembly (para
7-10) or WTEC III dashboard cable assembly
(para 7-11).
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to connector PX11 socket 1.
(3) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(4) If continuity is not present, repair wire
3020 from connector PX11 socket 1 to
connector PX6 socket 1 (para 2-45) or
replace WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(5) If continuity is present, replace WATER
TEMP gage (para 7-14).
(6) Connect connector PX24 to dimmer switch
connector.
(7) Connect connector clamp on dimmer
switch connector.
(8) Connect connector PX11 to WATER TEMP
gage connector.
(9) Connect connector clamp on WATER
TEMP gage connector.
(10) Install instrument panel assembly (para
7-15).
Change 1
2-391
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals