 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Remove instrument panel assembly for access
(para 7-15).
(2) Disconnect connector clamp from fuel gage
connector.
(3) Disconnect connector PX9 from fuel gage
connector.
(4) Set multimeter to volts dc.
(5) Connect positive (+) probe of multimeter
to connector PX9-3.
(6) Connect negative (-) probe of multimeter
to a known good ground.
(7) Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
digital multimeter.
(8) If 24 vdc is not present, repair wire 1546
from connector PX9 pin 3 to terminal board
TB1 position 61 (para 2-45) or replace
WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(9) Position master power switch to off
(TM 9-2320-366-10-1).
Change 1
2-319
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals