 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Position master power switch to on (TM 9-
2320-366-10-1).
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter to
circuit breaker socket 1, left of circuit
breaker CB70 on PDP.
(4) Connect negative (-) probe of multimeter to
ground and note reading on multimeter.
(5) If 12 VDC is not present, repair wire 1601
from bus bar X7 on PDP to terminal X2 on
PDP (para 2-45) or replace WTEC II
dashboard cable assembly (para 7-10) or
WTEC III dashboard cable assembly
(para 7-11).
(6) If 12 VDC is present, replace bus bar X7 on
PDP or WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(7) Position master power switch to off (TM 9-
2320-366-10-1).
(8) Install PDP cover (para 16-2).
Change 1
2-266.7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals